Based on the Red Seal Metal Fabricator (Fitter) exam blueprint: layout, cutting, forming, fitting, welding and finishing
Practice on the go and jump straight back to where you left off.
About the certification
In Ontario, Metal Fabricator (Fitter) is trade code 437A, a non-compulsory trade administered by Skilled Trades Ontario. Across Canada it is the Red Seal trade Metal Fabricator (Fitter), so passing the Certificate of Qualification exam also earns the interprovincial Red Seal endorsement.
The Red Seal exam has 130 multiple-choice questions in 3 blocks: common occupational skills (34 questions), fabricates components (56) and assembles components (40). Performing layout is the heaviest task with 24 questions. Between 35 and 45% of the questions test knowledge and recall, 50 to 60% procedural and application, and under 10% critical thinking. The Red Seal self-assessment guide gives the pass mark as 70%.
ExamHub's free 437A practice quiz has 195 original questions weighted to the real exam blocks and tasks, with an explanation and a source for every answer. Safety questions use Ontario's Industrial Establishments regulation (O. Reg. 851) and free CCOHS guidance, and trade questions follow the Red Seal Occupational Standard.
What's covered
Categories follow the 12 Red Seal exam tasks, weighted like the real exam.
Try a few
Five sample questions from the question bank, with the answer and explanation.
Why: A work rest must have a maximum clearance of three millimetres from the wheel, be positioned above the centre line of the wheel, and must not be adjusted while the wheel is in motion. A wide gap lets the work jam between the rest and the wheel.
Why: Each leg carries half the load divided by the sine of the angle to the horizontal: 500 / sin 30 degrees = 1,000 kg. The smaller the sling angle, the higher the tension, which is why CCOHS says a smaller angle reduces what the sling can carry.
Why: The neutral axis diameter is the inside diameter plus one plate thickness: 500 + 10 = 510 mm. The developed length is pi x 510 = 1,602 mm. Using the inside diameter (1,571 mm) would make the shell too small.
Why: Oxy-fuel cutting works by burning the steel in a stream of oxygen. Stainless steel forms a high-melting chromium oxide skin that stops the process, so plasma or another method is used instead.
Why: The Galvanizers Association guidance is that items enter and leave the baths at an angle, so vents sit at the highest point and drains at the lowest point as mounted for galvanizing. This allows air and liquid to escape during immersion and withdrawal.
FAQ
The Red Seal Metal Fabricator (Fitter) exam has 130 multiple-choice questions. ExamHub's bank has 195 questions, and Test Mode draws a 130-question timed simulation.
The Red Seal self-assessment guide for this trade gives the pass mark as 70%. The Red Seal exam page does not state a time limit, and ExamHub's Test Mode allows up to 4 hours.
3 blocks: common occupational skills (34 questions), fabricates components (56) and assembles components (40). The tasks with the most questions are performing layout (24), fitting and fastening sub-components and components (19) and cutting materials (17).
No. Metal Fabricator (Fitter) (437A) is a non-compulsory trade in Ontario. Skilled Trades Ontario issues the Certificate of Qualification when the exam is passed, and the trade is part of the Red Seal program.
No. These are original practice questions written from the Red Seal standard and free public sources. They are not copies of exam questions.