Based on Part 33 (Explosives) of the Alberta OHS Code and the Government of Alberta's blaster certification guide
Practice on the go and jump straight back to where you left off.
About the examination
In Alberta, any worker who uses, handles, prepares, loads, fires, burns or destroys an explosive or detonator must hold a blaster's certificate, or work under the direct supervision of a blaster. The certificate is issued after an application, proof of the required qualifications and an exam on the relevant legislation, with a 70% pass mark.
Alberta does not publish how many questions the exam has or how long it takes, so the 40-question, 60-minute timed test here is typical, not official. This free practice test has 140 original questions drawn from Part 33 (Explosives) of the Occupational Health and Safety Code: certification, storage, transport, handling, loading, firing, misfires, specific blasting activities and mines.
Quick facts
What’s covered
Alberta publishes no topic weights. The areas below follow the structure of Part 33 of the OHS Code, with more questions where it holds the most distinct rules.
Try a few
Sample questions from the bank. Use the interactive module above for the 40-question timed test.
Why: Section 468(1) says a worker who loads, primes or otherwise works directly with explosives must be a blaster or under the direct supervision of a blaster. Employer training or a boss's permission does not replace that.
Why: Section 509(1) bars return until the later of the end of the longer of 10 minutes after the last explosive was detonated or should have detonated, the manufacturer's period, or the period set by a blaster, and the time needed for the blaster's inspection.
Why: Section 517.99(2) says an explosive is not loaded or detonated if, within 25 metres of a bore hole or blast hole, the atmosphere contains more than 1 percent methane or 20 percent of the lower explosive limit of a flammable gas, untreated combustible dust is present, or the area has not been thoroughly wetted.
Why: Section 481(1) requires an explosive to be primed as close to the location of the blasting activity as reasonably practicable, and only the workers needed to prime it to be present.
FAQ
Any worker who uses, handles, prepares, loads, fires, burns or destroys an explosive or detonator must hold a blaster's certificate, or work under the direct supervision of a blaster (OHS Code, s. 468). Driving explosives in a vehicle is excepted from that rule. Sources: alberta.ca (Blaster's certificate) and OHS Code Part 33, read 10 Nov 2026.
Alberta's guide says the exam contains relevant legislation questions and a minimum of 70% is needed to pass. Alberta does not publish the number of questions or the time limit, so this site's 40-question, 60-minute timed test is a typical length, not an official one. After a failed attempt the guide sets waits of 48 hours (2nd attempt), 30 days (3rd) and 90 days (4th and later). Source: Guide for Alberta's Blaster's Certification Program (May 2024), s. 2.5, read 10 Nov 2026.
A certificate is typically valid for five years from the date of issue, and alberta.ca calls five years the maximum. A Director may issue one for a shorter period, case by case or on request. Sources: the Guide, s. 2.4, and alberta.ca (Blaster's certificate), read 10 Nov 2026.
Category A covers avalanche control, beaver dam, high energy joining, surface blasting, seismic blasting, oil or gas well perforating and other work. Category B covers surface mine and underground mine blasting. A Category A applicant qualifies through a training course (apply within 90 days of finishing it), qualifications acceptable to the Director, or at least six months of supervised experience in the last 36 months. A Category B applicant needs at least three years of mining experience and training under a blaster of that mine type. Source: the Guide, Appendix A, read 10 Nov 2026.
Apply online through the secure portal, or send the application form and documents by email. An application sent through other methods is acknowledged within three business days, and a Director communicates the review decision within 20 business days. If you are approved you are invited to write the exam, and after you pass, your certificate and identification card are issued. Source: the Guide, s. 2.1 to 2.2, read 10 Nov 2026.
An applicant with a current and comparable certificate from another Canadian jurisdiction applies as an out-of-province applicant, supplies a copy of the certificate, and must write a legislation-based exam as part of the approval. The Director validates the certificate with the issuing authority. Sources: the Guide, s. 2.2, and alberta.ca (Blaster's certificate), read 10 Nov 2026.
No. ExamHub is an independent study resource, not affiliated with the Government of Alberta, and the questions are original, not the real exam questions. They are written from Part 33 (Explosives) of the Occupational Health and Safety Code and the Government of Alberta's certification guide, and each explanation names its section.
Sources
Checked 14 Nov 2026. Always confirm current details with the official pages.