425A Agricultural Equipment Technician Practice Quiz
Free · 220 Questions.

Based on the Red Seal Agricultural Equipment Technician exam blueprint: engines, drive trains, hydraulics, electronics, precision farming and harvesting equipment

📝 125 Q practice test✅ Pass: 70%⏱ Up to 4 hr🔁 Free retakes Updated: October 2026
⚠️ExamHub is an independent study resource and is not affiliated with, endorsed by, or reviewed by Skilled Trades Ontario or the Red Seal program. Questions are original practice materials.
Choose your mode
Mode 1
Test Me
125 questions with a 240-minute timer. 70% (88/125) to pass, with complete answer review at the end.
⏱ 240 min125 Qs70% to passAnswer review
Mode 2
Practice
Sequential practice with detailed explanations after every question. Numbered navigator with auto-saving progress.
📖 Explanations🔊 Voice narrationAuto-save
Or practice by topic
Common Occupational Skills
10 questions
Engines and Engine Support Systems
32 questions
Drive Trains
28 questions
Hydraulic, Hydrostatic and Pneumatic Systems
39 questions
Electrical and Electronic Systems
42 questions
Steering, Brakes, Tracks, Wheels and Suspension
23 questions
Structure, Operator Station and Climate Control
14 questions
Agricultural Equipment
32 questions
📲 Add 425A Agricultural Equipment Technician Practice Quiz to your Home Screen

Practice on the go and jump straight back to where you left off.

About the certification

Agricultural Equipment Technician (425A) Certificate of Qualification

In Ontario, Agricultural Equipment Technician is trade code 425A, a non-compulsory trade administered by Skilled Trades Ontario. Across Canada it is the Red Seal trade Agricultural Equipment Technician, so passing the Certificate of Qualification exam also earns the interprovincial Red Seal endorsement.

The Red Seal exam has 125 multiple-choice questions across 8 blocks. The heaviest are electrical and electronic systems (24 questions), hydraulic, hydrostatic and pneumatic systems (22), engines (18) and agricultural equipment (18). Under 5% of questions are pure recall; most are procedural or critical-thinking scenarios. Red Seal doesn't publish the pass mark on the exam page; 70% is the standard.

ExamHub's free 425A practice quiz has 220 original questions weighted to the real exam blocks, with an explanation and a source for every answer.

What's covered

220 practice questions, by category

Categories follow the 8 Red Seal exam blocks, weighted like the real exam.

Topic breakdown

  • Common Occupational Skills10
  • Engines and Engine Support Systems32
  • Drive Trains28
  • Hydraulic, Hydrostatic and Pneumatic Systems39

 

  • Electrical and Electronic Systems42
  • Steering, Brakes, Tracks, Wheels and Suspension23
  • Structure, Operator Station and Climate Control14
  • Agricultural Equipment32

Try a few

Sample 425A Agricultural Equipment practice questions

Five sample questions from the question bank, with the answer and explanation.

Question 1
A farmer drives a tractor towing two implements on an Ontario highway. Where must the slow moving vehicle (SMV) sign be attached?
  • On the rear of the rearmost implement being towed
  • On the front of the tractor above the grille
  • On the cab door beside the operator
  • On the tractor itself, behind the seat

Why: Under section 76 of the Highway Traffic Act, a farm tractor is a slow moving vehicle and the sign goes on the rear of the rearmost implement being towed. It is not required when the vehicle only crosses the highway directly.

Question 2
During a compression test, cylinder 3 reads far below the others. After a small amount of oil is added to that cylinder, the reading rises sharply. What does this show?
  • The piston rings on cylinder 3 are leaking
  • The head gasket is leaking into the next cylinder
  • An intake valve on cylinder 3 is burned
  • The injector on cylinder 3 is stuck open

Why: Oil temporarily seals worn rings, so a big rise points to the rings. If a valve or the head gasket were leaking, oil would not raise the reading.

Question 3
In a closed-center system with a pressure-compensated pump, what does the pump do when all valves are in neutral?
  • Reduces displacement to near zero and holds the standby pressure
  • Delivers full flow across the relief valve and back to the tank
  • Stops turning until a control valve is moved by the operator
  • Reverses its flow direction to unload to the reservoir

Why: The compensator reduces pump displacement when pressure reaches its setting, so the pump supplies only the leakage flow. This saves power and limits heat.

Question 4
With the power off, a CAN bus has a 120 Ω terminating resistor at each end. What resistance should a meter read between CAN-H and CAN-L?
  • About 60 Ω
  • About 120 Ω
  • About 240 Ω
  • About 40 Ω

Why: The two 120 Ω resistors are in parallel across the bus, so the meter reads half of one, about 60 Ω. Any other value suggests a missing or extra terminator or a wiring fault.

Question 5
A boom sprayer has nozzles on 0.5 m spacing, each delivering 1.2 L/min, and travels at 12 km/h. What is the application rate?
  • 120 L/ha
  • 240 L/ha
  • 60 L/ha
  • 12 L/ha

Why: Rate (L/ha) = flow (L/min) × 600 ÷ (speed in km/h × nozzle spacing in m) = 1.2 × 600 ÷ (12 × 0.5) = 720 ÷ 6 = 120 L/ha.

FAQ

425A Agricultural Equipment questions, answered

How many questions are on the 425A Red Seal exam?

The Red Seal Agricultural Equipment Technician exam has 125 multiple-choice questions. ExamHub's bank has 220 questions, and Test Mode draws a full 125-question timed simulation.

What is the pass mark for the 425A exam?

The Red Seal exam page doesn't state it. Provincial exam information for this trade gives 70%, which is the standard Red Seal pass mark, and ExamHub's Test Mode uses 70% with up to 4 hours.

What topics are on the Agricultural Equipment Technician exam?

8 blocks: common occupational skills (6 questions), engines and engine support systems (18), drive trains (16), hydraulic, hydrostatic and pneumatic systems (22), electrical and electronic systems (24), steering, brakes and suspensions (13), structural components and operator stations (8), and agricultural equipment (18).

Is the 425A trade compulsory in Ontario?

No. Agricultural Equipment Technician (425A) is a non-compulsory trade in Ontario. Skilled Trades Ontario issues the Certificate of Qualification when the exam is passed, and the trade is part of the Red Seal program.

Are these the real exam questions?

No. These are original practice questions written from the Red Seal standard and free public sources. They are not copies of exam questions.

Other free practice tests

421A Heavy Duty Technician
220 questions
220 questions on hydraulics, diesel engines, electrical diagnostics, drivetrains, and undercarriages.
310T Truck & Coach Tech
220 questions
220 questions on engines, air brakes, electrical and drive trains.
339B Tower Crane Operator
150 questions
150 questions on tower crane safety, inspection, climbing, lift planning, rigging and operation.
636A Tractor-Loader-Backhoe (Red Seal)
200 questions
200 questions on TLB safety, inspection, backhoe trenching, loader work and truck loading.
636B Excavator Operator (Red Seal)
210 questions
210 questions on excavator safety, inspection, trenching, lifting and truck loading.
690H RV Technician
178 questionsNew
178 questions on RV plumbing, electrical, LP gas, appliances, slide-outs and towing.
410N Automotive Painter
210 questionsNew
210 questions on surface prep, colour matching, spray equipment and safety.
636C Dozer Operator (Red Seal)
210 questionsNew
210 questions on dozer safety, inspection, grading, ripping and pushing material.