445A Appliance Service Tech Practice Quiz
Free · 150 Questions.

Based on the Red Seal Appliance Service Technician exam blueprint: electrical and electronic, mechanical, water, air and sealed refrigeration systems

📝 120 Q practice test✅ Pass: 70%⏱ Up to 4 hr🔁 Free retakes Updated: October 2026
⚠️ExamHub is an independent study resource and is not affiliated with, endorsed by, or reviewed by Skilled Trades Ontario or the Red Seal program. Questions are original practice materials.
Choose your mode
Mode 1
Test Me
120 questions with a 240-minute timer. 70% (84/120) to pass, with complete answer review at the end.
⏱ 240 min120 Qs70% to passAnswer review
Mode 2
Practice
Sequential practice with detailed explanations after every question. Numbered navigator with auto-saving progress.
📖 Explanations🔊 Voice narrationAuto-save
Or practice by topic
Safety and Lockout
3 questions
Tools and Recovery Equipment
3 questions
Installation and Removal
4 questions
Electrical and Electronic Diagnosis
29 questions
Electrical and Electronic Repair
16 questions
Drive Systems and Cabinets
16 questions
Suspension Systems
11 questions
Water Systems
18 questions
Air Systems
14 questions
Sealed System Diagnosis
15 questions
Refrigerant Recovery
8 questions
Sealed System Repair
13 questions
📲 Add 445A Appliance Service Tech Practice Quiz to your Home Screen

Practice on the go and jump straight back to where you left off.

About the certification

Appliance Service Technician (445A) Certificate of Qualification

In Ontario, Appliance Service Technician is a non-compulsory trade administered by Skilled Trades Ontario. The apprenticeship is 6,000 hours: 5,280 on the job and 720 in school. Across Canada it is the Red Seal trade Appliance Service Technician, so passing the Certificate of Qualification exam also earns the interprovincial Red Seal endorsement.

The Red Seal exam has 120 multiple-choice questions in 6 blocks: occupational skills (8 questions), electrical and electronic systems (36), mechanical systems (22), water systems (14), air systems (11) and refrigeration sealed systems (29). Diagnosing electrical and electronic components is the heaviest task with 23 questions. Block G, gas systems, is not common core and has no questions. Between 40 and 50% of the questions test procedural knowledge and application, 35 to 45% critical thinking, and 10 to 20% knowledge and recall. The Red Seal self-assessment guide gives the pass mark as 70%.

ExamHub's free 445A practice quiz has 150 original questions weighted to the real exam blocks and tasks, with an explanation and a source for every answer. Refrigerant handling questions use Ontario Regulation 463/10 (ozone-depleting substances and other halocarbons) and the federal Environmental Code of Practice for refrigerants, with the Red Seal Appliance Service Technician standard as the blueprint.

What's covered

150 practice questions, by category

Categories group the 20 Red Seal exam tasks, weighted like the real exam.

Topic breakdown

  • Safety and Lockout3
  • Tools and Recovery Equipment3
  • Installation and Removal4
  • Electrical and Electronic Diagnosis29

 

  • Electrical and Electronic Repair16
  • Drive Systems and Cabinets16
  • Suspension Systems11
  • Water Systems18
  • Air Systems14
  • Sealed System Diagnosis15
  • Refrigerant Recovery8
  • Sealed System Repair13

Try a few

Sample 445A Appliance Service Technician practice questions

Five sample questions from the question bank, with the answer and explanation.

Question 1
A dryer element rated 5400 W at 240 V is removed and checked on the bench with an ohmmeter. About what resistance should a good element read?
  • About 11 Ω
  • About 22 Ω
  • About 2.7 Ω
  • About 43 Ω

Why: R = V² / P = 240² / 5400 ≈ 10.7 Ω. A reading of OL (infinite) shows an open element, and a reading much lower than expected suggests a shorted section.

Question 2
A technician wants to pressurize a repaired refrigerator system to look for leaks. Which gas should be used?
  • Dry nitrogen from a regulated cylinder
  • The system's own refrigerant charge
  • Compressed shop air from the compressor
  • Pure oxygen from a welding cylinder

Why: Regulations forbid charging a system with halocarbon only to leak test it. Dry nitrogen is inert and dry. Oxygen and oily compressed air are dangerous around oil in a system.

Question 3
A technician is replacing a compressor in a refrigerator and plans to vent the R-134a to the outdoors because the quantity is small. What does Ontario regulation say?
  • Discharging a halocarbon refrigerant to the environment is prohibited
  • Venting is allowed for small charges under 1 kg of refrigerant per job
  • Venting is allowed if done outdoors away from buildings
  • Venting is allowed with a written permit from the manufacturer

Why: O. Reg. 463/10 s. 19(1) forbids discharging a halocarbon refrigerant into the natural environment or within a building. The refrigerant must be recovered into a suitable cylinder.

Question 4
According to the manufacturer's technical manual for a 24-inch built-in dishwasher, what supply water pressure range is specified for proper filling?
  • 20 psi minimum to 120 psi maximum
  • 5 psi minimum to 20 psi maximum
  • 60 psi minimum to 200 psi maximum
  • 0 psi minimum to 10 psi maximum

Why: The Whirlpool technical manual lists a supply flow requirement with a minimum of 20 psi and a maximum of 120 psi. Pressures outside this range cause slow filling or damaged valves and hoses. Always read the specification for the model being serviced.

Question 5
A belt-drive top-load washer agitates normally, but the basket does not spin up during the spin cycle. The belt is intact. Which component should the technician inspect?
  • The clutch assembly and brake pads
  • The water inlet valve and its filter screens
  • The lid switch and its wiring harness
  • The drain hose and the standpipe fit

Why: The clutch transmits motor power to the basket for the spin. Worn clutch pads allow slipping, so the basket does not reach spin speed. The clutch is inspected and rebuilt or replaced.

FAQ

445A Appliance Service Technician questions, answered

How many questions are on the 445A Red Seal exam?

The Red Seal Appliance Service Technician exam has 120 multiple-choice questions. ExamHub's bank has 150 questions, and Test Mode draws a 120-question timed simulation.

What is the pass mark for the 445A exam?

The Red Seal self-assessment guide for this trade gives the pass mark as 70%. The Red Seal exam page does not state a time limit, and ExamHub's Test Mode allows up to 4 hours.

What topics are on the Appliance Service Technician exam?

6 blocks: occupational skills (8 questions), electrical and electronic systems (36), mechanical systems (22), water systems (14), air systems (11) and refrigeration sealed systems (29). Diagnosing electrical and electronic components is the heaviest task with 23 questions. Gas systems are not common core and are not on the exam.

Is the Appliance Service Technician trade compulsory in Ontario?

No. Appliance Service Technician is a non-compulsory trade in Ontario. Skilled Trades Ontario issues the Certificate of Qualification when the exam is passed, and the trade is part of the Red Seal program.

Are these the real exam questions?

No. These are original practice questions written from the Red Seal standard and free public sources. They are not copies of exam questions.

Other free practice tests

313A Refrigeration & A/C
150 questions
150 questions on refrigeration theory, charging, and commissioning.
309A Electrician
126 questions
126 questions on electrical code, wiring, and motor control.
TSSA G3 Gas Technician
200 questions
G3 certificate: O. Reg. 215/01 supervision, gas properties, piping and testing, venting basics and controls.
447A Instrumentation Control
202 questions
202 questions on transmitters, calibration, valves, safety systems, networks and PLCs.
Electrician Level 1
90 questions
90 questions on circuits, DC, magnetism, electronics and safety.
EDM-A Elevator Mechanic
140 questions
140 questions on TSSA O. Reg. 209/01, ASME A17.1/CSA B44, safety circuits, hydraulics, and governors.
434A Powerline Technician
177 questions
177 questions on live-line safety, structures, conductors, auxiliary equipment, switching and repairs.
Confined Space Entry
140 questions
140 questions on O. Reg. 632/05, atmospheric testing, ventilation, lockout and on-site rescue.